1/2" Copper Press-fit 45 Degree Elbow Fitting

About this item

A 1/2" copper press-fit 45-degree elbow makes a gentle bend in small-diameter water lines without a torch. This listing is for one new fitting at $84.96 from an independent eBay seller.

Why use a 45-degree press-fit elbow instead of a 90?

Two 45s make a smooth offset around a pipe, stud or beam, and a single one adjusts a run by a slight angle. Press-fit joints are made with a press tool, so skip the open flame in finished spaces.

• Size: 1/2" copper.
• Angle: 45 degrees.
• Joining: press-fit, so confirm your tool and jaw compatibility.
• Quantity: one piece.

Inspect the listing for the press system and any additional specs. Follow local code and permit rules for your project. Bulk buyers can request a wholesale quote on our site. Purchases are covered by the eBay Money Back Guarantee.